Technical dimensions and weights.

INFLATED SIZE
Length: 365 cm
Width: 103 cm

FOLDED & BAGGED SIZE
Height: 67 cm
Width: 40 cm
Thickness: 30 cm

Weight: 16 kg
Maximum floor pressure: 0.34 bar (5 psi)
Side tube and seat pressure: 0.2 bar (3 psi)

Number of seats: 1 or 2 seats

Content: kayak, bag, repair kit, 3 fins, user guide, inflation connector, strap.

PUMP NOT INCLUDED
For use with an Itiwit double-action hand pump with adapters

Inflation tips and floor positioning

Connect the ITIWIT pump (sold separately) by twisting the pump adapter 1/4 turn and inflate the floor to 5 psi. Finish by screwing the cap back on.
Put the floor inside the kayak and strap it at the ends. The floor valve must be aligned with the side tube valves located at the back of the kayak. The floor’s position must allow free access to the drain plugs located in the middle of the kayak.

Side tube and seat inflation tips

Connect the ITIWIT pump (sold separately) by twisting the pump adapter 1/4 turn and inflate the side tubes to 3 psi. Finish by screwing the cap back on. Each side tube has a pressure relief valve. Its purpose is to evacuate excess air resulting from overinflation. When this happens, you may notice a hissing sound. This hissing sound is normal, it can also occur during prolonged exposure to the sun. It will stop once the kayak reaches the correct internal pressure.

Seat comfort and positioning.

The seats are high, providing increased comfort for adults in the paddling position.
Position the seats on the floor using the velcro areas located under the seat and on the floor.
Stow any bags or equipment into the kayak’s rear hatch or attach to the rear deck.
The boat is ready to be launched.

Glide performance

The deck of the Itiwit 100+ is based on the same dropstitch construction as the inflatable stand-up paddle. Dropstitch is a mesh made of polyester yarns between 2 layers of PVC. When the floor is inflated under high pressure, the threads are stretched and the construction becomes very strong, thus avoiding any deformation.

Care instructions

Remove the seats and slightly deflate the floor to make it easier to rinse out.
Rinse the kayak, bottom and seats with clean water after each use to avoid damage from sand, salt water and sun.
Open the drain plugs located in the middle of the kayak and at the rear. Tip the kayak to empty out the water.

Disassembly & folding

Make sure that the surface you intend to fold the kayak on is clean. Remove the fins.
Deflate the side bladders. The valves are located at the back of the kayak. PLEASE NOTE: Do not unscrew the pressure relief valves at the front.
Fold the floor.
Fold the rest of the kayak in half lengthwise. Flatten the front fin base.
Lay the rolled floor on the front end. Roll the kayak to the rear end.
Strap the kayak.